Options available


Technical information

note options shown in this chart can

vary depending truck and/or options


Download Brochure



The RHS34 is a non-insulated telescoping platform that turns into steps with a working height of 34 ft. (10.36 m) and 26, 7 ft. (8,14 m) of side reach. The “S” in RHS34 is in referral in step because it can be used as a perfect flat platform and as it deploys itself becomes a 60-degree stairs case. 
This unit reflects the firm’s commitment to R&D and was developed in conjunction with the SOPFEU of Quebec, the RHS34 is tailored to the specific requirements of airport and aircraft maintenance and many more without compromising safety. This unit can be mounted on many smaller chassis.
The use of STRENX steel comes in handy; you get the ruggedness and quality RH Aerial Lift Equipment is known for, and its light weight allows the vehicle to move faster and be more efficient. Key in hand option is available. Please contact us to see what we can do for your chosen vehicle and arrangement

Call for more details


Est. working height  (A)10.3m (34')  
Horizontal reach      (B)8.51m (27' 11")  
Length (retracted)   (C)4.97m (16' 4")  
Interior width           (D)60 cm (23")  
Bucket capacity159 kg (350 lbs)  
Lifting ring 250 kg (550 lbs)  
Rotation360°  continuous opt.  
Elevation degrees-0° to 85°  
Approx. weight567 kg (1250 lbs)  
GVWR min. required4309 kg (9500 lbs)  
Hydraulic pressure20684 kPa (3000 psi)  


* Information shown can vary depending on truck and/or options
ask a representative for more details



The connection of the auxiliary battery isolates the vehicle’s aerial lift equipment. The unit will work without the vehicle engine on. In any case, it will affect the vehicle’s battery; it is actually an additional security because if the truck’s battery needs a little “boost”, due to the type of connection, it can feed of the auxiliary battery. All our units have a two-way splitter between the auxiliary battery and the vehicle. We make no modification to your vehicle, only a wire is connected to the alternator which is used to recharge the auxiliary battery when the vehicle is running.


In addition, we can provide additional security by adding a system such as Ozone-tech. This product requires removing the keys from the ignition; press an activator button to operate the unit. Ozone-tech is perfect for fleet owners that want to have some control over the fuel consumption. The system ensures optimum battery management and will turn on the engine if the vehicle needs to recharge the battery to its maximum capacity.



& Engineering

RH Ladder uses advanced structural optimizing simulations to ensure safety and  enhance toughness. Our engineering approach considers all attributes such as weight, resistance, quality, performance and  manufacturability.



This type of aerial ladder must be installed on vehicles whose GVWR (gross vehicle weight rating) is greater than 9,500 lbs (4,309 kg). Outriggers are generally not required. However, given the variety of configurations possible, outrigger requirements must be confirmed by means of stability tests performed on your bucket truck. 


The same applies to the bucket’s load-carrying capacity (in other words, the maximum weight authorized to be carried in the bucket). Specifically, this telescoping ladder is rated to carry 350 lbs (159 kg); however, its actual load-carrying capacity depends on the carrier vehicle. 


We encourage you to contact Robert Hydraulique to obtain more information on the restrictions and factors to be taken into account when installing RH telescoping aerial ladders so that you can meet the highest standards in quality and safety. 


*** Always ensure that you are complying with all local regulations when installing bucket-equipped aerial ladders. Robert Hydraulique is not responsible for installations performed outside its production facilities




Accuracy is crucial to achieve consistent quality. RH Ladder uses water jet and laser cutting, along with robotic welding, to deliver constant precision and reliability.

Water jet Cutting

Numeric tooling technologies